Clearaudio MAXIMUM SOLUTION User Manual download pdf (Page 24)

Maximum Solution

Bedienungsanleitung/USER MANUAL

Seite/Page 24 © clearaudio electronic GmbH 2007

Place all 3 motor drive units beside the round bases and bring all 3 motor drive unit power

cables to the place where your APG will stand. Tighten all 3 power cords straight. After that,

place the 3 motors on in a way, that all 3 blue LEDs show to the central spindle (shown on

the picture). You can leave the power cords of the 3 motors either outside of the chassis or

put them through the centre of the motorbasecassis mounting chassis.

Due to the high precision machining there could be left some air

inside the bearing. The air will flow out after several turns of the

platter. Please make sure, that the two markings on the turntable

platter and on the bearing are in one line (as shown in figure

right). The correct position of these markings is very important,

because they had been calibrated at the factory.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29

No comments

Clearaudio MAXIMUM SOLUTION User Manual Page 24