Clearaudio VTA LIFTER User Manual download pdf (Page 13)

VTA - Lifter

Bedienungsanleitung

Seite/Page 13  clearaudio electronic GmbH 2005

With help of the little hexkeywrench you are able to turn out the

fitting-sleeve by taking away the both maggot screws which are

positioned on the scope of the threat bore.

Now take the ring nut and push it from above onto the desired fitting

sleeve (advice to find out the right fitting sleeve can you see under

point 3) until the both threat bores which take place in the fitting

sleeve are accored with them in the ring nut. Afterwards screw the

two maggot screws which you have removed before into the two

threat bore again like ilustrated in the picture beside.

Before putting in the threat bore make sure that the lever of the lifter

is located in the „0“-position.

Put in the threat bore so that the lenghtcutmilling, which was added

sidewards, stands in the angle alpha to the lever of the lifter

(see picture).

Following turn in the threat bore clockwise until the

lenghtcutmilling can be seen for the first time on the

sidewards standing scope of the VTA-Lifter through the

mounted threat bore. Now screw in the maggot screw

again which you loosed before, so that it isn’t outside

the scope of the VTA-Lifter. Otherwise the bolt with

the big screw nut isn’t possible.

All following steps of the installation are described

under point 3.

1 2 ... 8 9 10 11 12 13 14 15

No comments

Clearaudio VTA LIFTER User Manual Page 13